Tabletop beaming and threading holder

The table top beaming and threading holder is a tool for threading a ready made warp or for winding and threading your own warp at a table. It is much more comfortable than winding a warp on the loom.

Use this tool with Kenzo’s dividing bar for beaming on your own handmade warp.

The kit comes with clamps to clamp to a table. You can use the warp beam and brake disk from your loom to hold the warp in place and for beaming on your own warp. You are able to use the reed cap from your loom, which fixes into the tool, to hold the reed in the correct position for threading.

For 60 series looms (WX60, SX60, SX60H, CH60) optional extras are –
Warp beam for table top beaming and threading holder – this is an extra warp beam with a handle that you can use instead of the warp beam from your loom.
Reed holder attachment – this holds the reed in place for threading instead of the reed cap from your loom.

For the Piccolo loom.
This tool can be used with the Piccolo loom harnesses and reeds by adding optional attachments –
Pipe holders to hold the harnesses and pipe holders for the Piccolo reed. The reed holder attachment (blocks) are needed to hold the reed.

Full instructions are included.
Please feel free to email if you have any questions.